Troubleshooting Electrical System Troubleshooting Symptom Problem Solution Voltage indicator displayed when there is low battery voltage (key ON and engine OFF) Defective battery Check electrolyte level and specific gravity Low charging voltage Have your John Deere dealer check charging circuit High resistance in charging circuit Have your John Deere dealer check charging circuit Indicator malfunction Have your John Deere dealer check indicator Voltage symbol displayed and service alert indicator flashing indicating low charging voltage (engine running) Low engine speed Increase speed Auxiliary drive belt slipping, not charging alternator Check auxiliary drive belt tension Defective battery Check electrolyte level and specific gravity Defective alternator Have your John Deere dealer check alternator Excessive electrical load Decrease load Voltage symbol displayed and service alert indicators flashing indicating excessive charging voltage Faulty connection to alternator Check wiring connections Defective regulator Have your John Deere dealer check alternator Voltage indicator flashing indicating excessive charging voltage Faulty connection to alternator Check wiring connections Bad/faulty alternator ground Clean mounting contact points ”Chirping” noise from side console Noise is normal Because 8030 series tractors use solid state electronic drivers instead of relays, the tractor warning system provides a short turn signal indictor beep replacing the normal relay clicking noise Batteries will not charge Loose or corroded connections Clean and tighten connections Sulfated or wornout batteries Check electrolyte level and specific gravity Loose or defective alternator belt Adjust auxiliary belt tension or replace belt Continued on next page OURX935,000018D 1903AUG051/2 12510 122208 PN=330