Diagnostic Trouble Codes SV Diagnostic Trouble Codes numeral. That is because the same trouble codes are available for each of the seven select control valves available on this tractor.
In column one of the following table only SV and the trouble code is listed without being followed by a Roman OURX935,0000093 1914AUG081/1 Setup Panel (SUP), Tractor Electronic Control Unit (TEC) and Tractor Electronic Interface (TEI) Diagnostic Trouble Codes OURX935,00004E2 1919DEC071/1 13025 122208 PN=359 SV Diagnostic Trouble Codes (SCV 1 Through SCV VII) Diagnostic Trouble Code Display Solution SV 000158.03 Switched Supply Voltage High Switched supply voltage to Selective Control Valve Unit I (SV) above 16.0 V. SV 000158.04 SV Switched Supply Voltage Low Switched supply voltage to Selective Control Valve Unit I (SV) below 9.0 V. SV 002034.09 SCC Message Missing Code Caused By:
Selective Control Valve Unit I (SV) not receiving required messages from the SCC. SV 004084.07 SV Not in Float Position Selective Control Valve Unit I (SV) not going into FLOAT position. SV 004084.16 SV Overshot Commanded Position Selective Control Valve Unit I (SV) valve spool is overshooting it’s desired position. SV 004084.18 SV Failed to Reach Commanded Position Selective Control Valve Unit I (SV) valve spool is undershooting it’s desired position. SV 004085.07 SV Not in NEUTRAL Position Selective Control Valve Unit I (SV) valve is not in NEUTRAL position. SV 004085.12 SV Control Unit Fault Selective Control Valve Unit I (SV) software failed to execute in allotted time.
Setup Panel (SUP) Diagnostic Trouble Codes Diagnostic Trouble Code Display Solution SUP 000628.12 Programming SUP Programming. SUP 000629.12 Electrical System SUP Control Unit Fault. Have your John Deere dealer repair as soon as possible. SUP 524013.03 Electrical System SUP Switch Fault. Have your John Deere dealer repair as soon as possible. Tractor Electronic Control Unit (TEC) Diagnostic Trouble Codes TEC 000628.12 Electrical System TEC Programming. TEC 000630.02 Electrical System TEC Calibration Fault/Data Invalid. Have your John Deere dealer repair as soon as possible. TEC 522550.14 Incompatible Device ISO Compliant and NonISO Compliant Devices on Implement Bus. Remove devices.
If code returns, have your John Deere dealer repair as soon as possible. Tractor Electronic Interface (TEI) Diagnostic Trouble Codes TEI 000628.12 Electrical System TEI Programming. TEI 000630.02 Electrical System TEI Calibration Fault/Data Invalid. Have your John Deere dealer repair as soon as possible. TEI 522550.14 Incompatible Device ISO Compliant and NonISO Compliant Devices on Implement Bus. Remove devices. If code returns, have your John Deere dealer repair as soon as possible.