John Deere Omar287594 — Paint Finish Care

Storage Placing Tractor in Storage IMPORTANT: If tractor will not be used for more than three months, the following recommendations for storage and removal from storage will minimize corrosion and deterioration. 6. Coat all exposed (machined) metal surfaces such as lift cylinders and steering cylinder rods with light coat of grease. NOTE: Whenever possible store tractor in a building or under a roof to avoid damage resulting from prolonged exposure to the elements. 7. Lubricate all grease fittings. 8. Release tension on auxiliary drive belt and remove belt from air conditioner pulley. 1. Lower hitch. If tractor must be stored outside, follow these additional precautions. 2.

Change engine oil and replace filter (if required). 1. Cover instrument panel, control levers and seat with sheets of material or cardboard to protect against sun rays. NOTE: Do not add bio­diesel fuel if placing tractor in storage. 3. Drain fuel tank and add back approximately 19 L (5 gal) of fuel. 2. Thoroughly clean tractor touching up any scratched or chipped painted surfaces. 3. Wax or cover entire tractor with waterproof material. 4. Using plastic bags and either tape or tie­bands, seal air inlets and exhaust, crankcase vent tube, radiator overflow hose, and transmission­hydraulic system fill cap. 4. Raise tires off the ground and/or cover them to protect from heat and sunlight. 5.

Remove and store batteries in a cool dry location—(keep batteries charged). 1 1 Disconnect battery ground cable for short­term storage periods (20 to 90 days) OURX935,0000445 ­19­10AUG05­1/1 Removing Tractor from Storage 1. Remove all coverings placed in or on tractor while preparing for storage. 7. Install batteries and connect cables. IMPORTANT: To avoid engine damage, make sure crankcase vent tube is unsealed after storage. 8. Turn key to RUN position for one minute to allow fuel system to prime, then start engine. NOTE: While operating engine at slow idle, visually check all instruments and indicators to ensure they function properly. 2. Unseal all openings sealed during storage. 3.

Check auxiliary drive belt for cracking and if serviceable, install auxiliary drive belt on air conditioner pulley. 9. Operate engine at slow idle for several minutes. 10. Perform all daily/10 Hour services and any other scheduled services as required. (See Service sections.) 4. Check all fluid levels. 5. Fill fuel tank. 6. Check tire inflation pressures. (See Wheels, Tires and Treads section.) 11. Warm up tractor before putting tractor under load. OURX935,0000446 ­19­14JUN05­1/1 135­1 122208 PN=361