Detroit Diesel — Detroit Diesel MBE 4000 Service Manual

MBE 4000 SERVICE MANUAL The vehicle is connected to dynamometer through the roller absorption unit. The load on the vehicle may be varied from zero to maximum by decreasing or increasing the resistance in the unit. The amount of power absorbed in a water brake type dynamometer, as an example, is governed by the volume of fluid within the working system. The fluid offers resistance to a rotating motion. By controlling the volume of water in the absorption unit, the load may be increased or decreased as required. The following are some tips to keep in mind in preparing the vehicle before the dynamometer run and during the actual testing:

Follow all applicable safety procedures from the chassis dynamometer manufacturer. Observe the air intake duct and charge air fan shrouding to identify misalignments. Correct as necessary. Make sure the differential lock is “on” if equipped. Make sure the radiator/charge air cooler system fan(s) are locked on. If the vehicle is equipped with anti-lock brakes (ABS), disable the ABS controller by unplugging it or removing its power fuse/breaker. Instrument the engine for fuel pressure, air inlet restriction, exhaust backpressure, and crankcase pressure, and note these readings during the dynamometer run. Make sure the vehicle hood is down and locked into its normal position.

Make sure the engine is fully warmed up before placing the vehicle on the dynamometer. Both oil and coolant temperature should be at least 82°C (180°F). When loading the vehicle on the dynamometer, make sure the vehicle is positioned onto the rollers as straight as possible. For direct engine cooling, Detroit Diesel recommends the use of a 368 m3 /min (13,000 ft3 /min) or greater capacity barrel-type ram air fan. This should be portable so that it can be conveniently placed three to five feet (approximately one to two meters) in front of the truck and aimed directly at the charge air cooler. This is especially important at high altitudes.

During high ambient temperature conditions [+90°F, (+32°C)], it may also be necessary to use a water spray mist fan in front of the vehicle to prevent overheating. Running the dynamometer in “manual” mode instead of “automatic” mode allows for maximum control of the test process and may result in more consistent test results. During the horsepower test, make sure “percent engine load” is 100% and smoke limited is not active by monitoring them with a computer equipped with DDDL. Select a transmission gear with a 1:1 gear ratio during the horsepower test. Take horsepower reading at 1300 rpm and 1850 rpm. Stabilize at rated speed for at least one minute before taking a final horsepower reading.

Compare the recorded horsepower to the appropriate minimum horsepower tables below for particular ratings. All information subject to change without notice. (Rev. 2007) 6SE412 0702 Copyright © 2007 DETROIT DIESEL CORPORATION From Bulletin 1–MBE 4000–07 17-23