WHEN REQUIRED 3. Steering column (1 point) g. REPLACING END BIT AND CUTTING EDGE heavy or does not return properly, If the play of the steering column is edge are worn, replace them as fol- When the end bit and the cutting reverse the cutting edge. Remove bolt (1) and nut (2), then apply grease. lows. If the cutting edges on both sides Raise the blade to a convenient height, and put blocks under the are worn out, replace with new one. down. blade to prevent it from coming Tightening torque of mounting bolt: 92 f 4 kgm Raise the blade so that the bottom Fit the edge to the blade, tighten is horizontal.
Remove bolt (1) and nut (21, then times to the ground, and remove temporarily, lower the blade 3 - 5 replace the end bit with new one. If the bolt and nut are worn out, the clearance at bolts (I) and (3). Afterdoingthis,tightenthe boltsto Tighteningtorqueof mounting bolt: replace with new one. the correct tightening torque. After operating for several hours, 92 f 4 kgm tighten again to the correct tight- ening torque. -124-