TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE This guide is not intended to cover every conditions, however many of the more common possibilities are listed. ELECTRICAL SYSTEM Lamp does not glow brightly even when engine runs at high The starting motor disengages before the engine starts up speed. Lamp flickers while engine runs. l Check and repair the wiring. l Charge the battery. . Adjust belt tension. . Check for loose terminals and open-circuit wiring. The engine pre-heating monitor does not flash. Charge monitor does not go out even when engine runs at high l Check and repair wiring. . Replace the heater relay. speed. l Replace the alternator.
The engine oil pressure monitor does not light up when engine l Replace the monitor. l Inspect and repair wiring. is stationary (when the starting switch is in ON position.) . Replace the monitor. Unusual noise is emitted from the alternator. l Replace the alternator. l Repair or replace the sensor. l Check wiring. Starting motor does not turn when starting switch is turned on. l Inspect and repair the wiring. Charge monitor does not light up when the engine is stationary. l Charge the battery. l Replace the monitor. (When the starting switch is in ON position.) The pinion of the starting motor keeps going in and out. l Charge the battery. . Inspect and repair the wiring.
Starting motor turns the engine sluggishly. l Charge the battery. l Replace the starting motor. - 132- W-02881