OPERATING YOUR MACHINE MAXIMUM DEPTH OF WATER When working in water or on OR DOWN SLOPES PRECAUTIONS WHEN DRIVING UP come above the bottom of the axle swampy ground, do not let the water Lower the center of gravity when Braking on downhill slopes If the service brake is used too * After finishing the operation, wash housing. turning. When turning on slopes, lower the frequently when traveling downhill, the brake may overheat and be dam- and check the lubricating points. workequipmenttolowerthecenterof aged. To avoid this problem, shift Axle housing / to turn the machine with the work gravity before turning.
It is dangerous down to a low range and make full use of the braking force of the engine. equipment raised. When braking, use the right brake pedal. If the speed control lever is not torqueconverteroil may overheat. If it placed in a proper speed position, the IF WHEEL BRAKE DOES NOT WORK If the machine is not stopped by overheats, place the speed control lever in the next lower gear speed to depressing brake pedal, use the park- lower the oil temperature. If the temperature gauge does not ing brake to stop the machine.
indicate the green range of the scale even with the lever in the 1st speed position, stop the machine, place the medium speed until the gauge indi- lever in neutral, and run the engine at cates the green range. - 59 -