Komatsu — TRANSPORTATION

TRANSPORTATION TRANSPORTATION When transporting the machine, observe the various road rules, road transportation vehicle laws and vehicle limit ordinances, etc. It is a good idea to obtain a special platform for loading and unloading the ma- chine. When it is unavoidably necessary to use a gangplank, however, at the very least observe the following for the sake of safety. 1 Properly apply the brakes on the trailer and insert blocks beneath the tires to ensure that it does not move. Then fix the gangplank in line with the centers of the trailer and the machine. Make sure the gangplank has suf- ficient width, length and thick- ness to enable the machine to be safely loaded and unloaded.

If the gangplank sags appre- ciably, reinforce it with blocks, etc. Determine the direction of the gangplank, then slowly load or unload the machine. Sr When transmission cut-off switch is put in OFF, the left brake pedal and accelerator pedal can be operated at the Lower the blade and lock each control lever using safety lock. When transportating the ma- chine, place blocks underneath the front and rear wheels to pre- vent the machine from moving about. Also, hold it down with chains or wire ropes. Determine the route for trans- porting the machine by taking into account the width, height and weight of the machine. A When loading the machine, park the trailer on*a flat firm roadbed.

Keep a fairly long dis- tance between the road shoul- der and the machine. 4. 5. same time. * Remove all the mud from the un- * dercarriage to prevent the ma- chine from slipping to the side on hilly roads. * A Do not on any account change the direction of the machine while it is on the gangplank. To change the direction of the ma- chine, first take it down from the gangplank. 2. 3. Correctly load the machine onto the specified part of the trailer. M’-03709 - 67 -