COLD WEATHER OPERATION STARTING USING MANUAL PREHEATING 8. If starting, return key of starting switch (2) to ON position, * After starting the engine, when the water temperature reaches about 20X, the after-heating is automatically cancelled and the after-heating monitor lamp goes out. The time taken for the after- (When releasing the key, it will automatically return to ON.) When the engine water tempera- ture is above 13”C, automatic pre- heating cannot be carried out. (When the preheat switch is turned to AUTO, the preheating monitor lamp goes out.) If it is difficult to start the engine, use the following procedure. 1) Put starting switch key to ON position.
2) Keep the preheater switch in ON position with hand until the preheating monitor goes off. 3) As soon as light goes off, quickly return starting switch to START position, and start engine. OFF heating lamp to go out depends on the ambient temperature. temperature engine until after-heating monitor aoes out Ambient Time taken after starting * If the engine does not start through the steps specified above, turn key of the starting switch to OFF position and repeat Steps 2 to 8 at an interval of approx. 2 minutes. After starting the engine, when afterheating monitor goes off, turn preheater switch (4) in OFF position.
If a work operation starts with forgetting to turn preheater switch to OFF position, the ex- haust color will become bad, the horsepower will drop, and the life of the glow plug will be short- ened, therefore, always be sure to put preheater switch in OFF position. Do not run engine rpm higher than middle speed rpm. 9. 4) After starting, put preheater switch in OFF position. w-03711 -75-