Bulkhead Module 54.12 Bulkhead Module Fault Code Information General Information Suspect Parameter Number (SPN) Indicates what function on the ECU has failed. All J1939 SPNs for the BHM are listed in Table 2 . Subject 410 contains information on all proprietary Bulkhead Module (BHM) fault codes for J1587 and J1939 datalink protocols, how to view these codes, and what the codes mean. Each fault code contains three distinct pieces of information. Failure Mode Indicator (FMI) Indicates in what way the function failed. See Table 3 for a list of all failure mode identifiers for both datalink protocols. J1587 fault codes consist of the following elements in the order listed:
References such as BHM B1.A indicate that the fault is sensed to be coming from the Bulkhead Module, connector B1, pin A. Similarly, CHM indicates the Chassis Module on a vehicle. Module Identifier (MID) Identifies which elec- tronic control unit (ECU) the fault is coming from. The J1587 MID identifying all Bulkhead Module information faults is 164. J1587 fault codes are shown under J1708 in Service- Link. J1587 and J1708 are essentially the same datalink protocol. Subsystem Identifier (SID) Indicates what function on the ECU has failed. All J1587 SIDs for the BHM are listed in Table 1 .
Because the SAE J1939 subcommittee approves new SPNs for use in J1939 messaging on a con- tinual basis, J1939 SPNs used for diagnostic mes- sages could change when the Bulkhead Module part changes. These changes could impact any diagnos- tic message with an SPN value of 6915 or higher. Failure Mode Indicator (FMI) Indicates in what way the function failed. J1939 fault codes consist of the following elements in the order listed: Source Address (SA) Identifies which ECU the fault is coming from. The J1939 SA identi- fying all Bulkhead Module faults is 33.
J1587 SIDs for Bulkhead Module (BHM) MID 164 SID Description Possible FMI 000 Backlighting Dimmer Switch Fault 7 001 Clutch Switch Fault 7 002 Reserved for Future Use 003 Headlamp Switch Disagreement–Both park and on inputs are closed 7 004 Multifunction Turn Signal Switch High Beam Input Fault 2 005 Ignition Switch Fault 7 006 Marker Interrupt Switch Fault 7 007 Multifunction Turn Signal Switch Disagreement–Both wiper high and wiper low inputs are on.
2 008 Multifunction Turn Signal Switch Disagreement–Wiper on/off is off and wiper high or low input is on 2 009 Wiper Park Input Fault 7 010 ICU3-M2 Hazard Switch CAN Feedback Error 2 012 Multifunction Turn Signal Switch Right Turn Signal Input Fault 2 011 Multifunction Turn Signal Switch Left Turn Signal Input Fault 2 013 Multifunction Turn Signal Switch Washer Switch Input Fault 2 014 Multifunction Turn Signal Switch Wiper On/Off Input Fault 2 Business Class M2 Workshop Manual, Supplement 22, September 2012 410/1