mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

PTO and Pump Electrical Controls 54.38 Troubleshooting Fire Pump Controls Function Electrical Diagnosis Test No. Test Procedure Test Result Action 5 In ServiceLink, open the "Chassis Module Battery Inputs" Datalink Monitor template. The problem is in one or both of the fire pump solenoid output circuits. Is Battery Power Feed No. 3 at approximately battery voltage? Make sure the fire pump solenoids are wired to the correct CHM output pins per the ServiceLink CHM Configuration screen. Check both fire pump solenoid output circuits from the CHM to the solenoids, including the solenoid coil ground circuit, for opens.

Yes Check both solenoid output circuits between the CHM and solenoids for short to ground. This will cause the CHM solenoid output to shut off due to high current. The current draw must not exceed 0.85A. Check the solenoid(s). See Section 42.19. If all of the above is OK, replace the CHM. Check fuse 13 in the PDM. If blown, locate and correct the source of high current. No If fuse 13 is OK, check wiring between PDM fuse 13 and CHM pin C4-J for open circuit. Table 2, Fire Pump Controls Function Electrical Diagnosis PTO and Fire Pump Control Switch and Interlocks Test Test No. Test Procedure Test Result Action 1 In ServiceLink, open the "Dash Smart Switches" Data Monitor template.

Go to test no. 6. NOTE: Be sure to open the correct template for the BHM software version on the vehicle. Yes Look at each of the five BHM outputs: SS1 ID#, SS2 ID#, SS3 ID#, SS4 ID#, and SS5 ID#. If diagnosing the PTO, are any of the five SSn ID#s equal to 38? Go to test no. 2. No If diagnosing the fire pump controls, are any of the five SSn ID#s equal to 104? Business Class M2 Workshop Manual, Supplement 22, September 2012 300/5