PTO and Pump Electrical Controls 54.38 Troubleshooting Fire Pump Control Interlocks by Reference Parameter Reference Parameter Description Interlocks Indicated Vehicle Speed from Engine * Ignition (BHM input) Park Brake (from CHM) 26-01032-004 PTO Fire Pump Control (Smart Switch ID#104) On Set 26-01032-010 PTO Fire Pump Control, w/Park Brake & Veh Spd Interlocks (Smart Switch ID#104) Approximately 5 mph (8 km/h) On Set * The fire pump is driven by a transfer case. When the transfer case is shifted to deliver power to the fire pump, the transmission is put into gear to drive the transfer case (the vehicle will be stationary).
Since the transmission drives the transfer case, an apparent output shaft speed will register indicating vehicle speed. In order to engage the fire pump, this apparent output shaft speed must be under 5 mph (8 km/h). Once the transfer case is engaged, it will remain en- gaged regardless of the apparent output shaft speed as long as the ignition is on, the park brake is set, and the pump smart switch remains on.
Table 5, Fire Pump Control Interlocks by Reference Parameter PTO and Fire Pump Control J1587 Fault Codes MID SID FMI Description Action 164 025 07 End of Frame Air (PTO and fire pump control)–unexpected air pressure feedback Solenoid is not activated, but CHM senses that the pressure switch is in an unexpected state. For example, a normally closed solenoid is off, but air pressure is detected. Check the following: Air system Pressure feedback circuit including the ground. Solenoid–pressure switch may be stuck.
026 07 End of Frame (PTO and fire pump control)–no air pressure feedback Chassis Module engages solenoid, but the pressure switch does not change status indicating that the so- lenoid supplied, or exhausted, air downstream. Check the following: Air system Pressure feedback circuit including the ground. Solenoid–pressure switch may be stuck. Table 6, PTO and Fire Pump Control J1587 Fault Codes Business Class M2 Workshop Manual, Supplement 22, September 2012 300/8