mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Component Tests WARNING Sensor Voltage Output Test Before working on or around hydraulic brake systems and components, see Safety Precau- tions 100 . Failure to do so may result in personal injury. IMPORTANT: Sensor output voltage must be at least 0.2 volts AC at 30 rpm. WARNING Voltage Check Block the wheels to prevent the vehicle from moving. Support the vehicle with safety stands. Do not work under a vehicle supported only by jacks. Jacks can slip and fall over. Serious per- sonal injury can result. NOTE: Along with the following, the voltage can also be checked using the Meritor WABCO TOOLBOX Software. 1.

Park the vehicle on a level surface and apply the parking brakes. Shut down the engine. Chock the front and rear tires to prevent vehicle move- ment. IMPORTANT: Voltage must be between 9.5 and 14 volts for the 12-volt hydraulic ABS to function properly. 1. Park the vehicle on a level surface and apply the parking brakes. Shut down the engine. Chock the rear tires to prevent vehicle movement. 2. Turn the ignition off. 3. To measure voltage at the pins on the sensor connector, disconnect the sensor from the chas- sis harness. 2. Turn the ignition on. 3. Check the voltage between Pins 9 and 3, 9 and 2, and 9 and 11 on the black X2 ECU connector. 4. Raise the vehicle off of the ground.

Put safety stands under the axle. 4. If voltage is not between 9.5 and 14 volts, verify proper wiring connections. Make corrections as required. 5. Rotate the wheel by hand at 30 rpm (1/2 revolu- tion per second). 6. Measure the voltage across the two pins at the sensor connector. 5. Remove the chocks from the rear tires. ABS Indicator Light 7. If the voltage is not greater than 0.2 volts AC, adjust the sensor and recheck. If the voltage is still not greater than 0.2 volts AC, replace the sensor. IMPORTANT: If the ABS indicator light does not come on after the ignition is turned on, check all ABS fuses or circuit breakers and replace if necessary.

Check the wiring to the ABS indica- tor light and repair or replace the wiring as re- quired. 8. Remove the safety stands and lower the vehicle. 9. Remove the chocks from the rear tires. Sensor Resistance 1. Park the vehicle on a level surface and apply the parking brakes. Shut down the engine. Chock the rear tires to prevent vehicle movement. IMPORTANT: The sensor resistance must be between 500 and 2000 ohms. Measure resis- tance at the sensor connector or at the pins on the ECU connector. 2. Check the voltage potential at the light socket. 3. Check the continuity of the wires to the socket. 1. Park the vehicle on a level surface and apply the parking brakes. Shut down the engine.

Chock the rear tires to prevent vehicle movement. 4. Replace the bulb. 5. Remove the chocks from the rear tires. 2. Turn the ignition off. Business Class M2 Workshop Manual, Supplement 3, January 2002 140/1