Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Troubleshooting J1587 Fault 136-002 Right Front Wheel Sensor MID SID FMI Problem Test Test Result Action Resistance reading between 500 and 2000 ohms Check for intermittent, loose or poor connections in Circuits 377RF+ and 377RF– and repair as necessary. If the problem persists, suspect the ECU is at fault. 2. Measure the resistance across Pins 4 and 9 of the green X3 ECU connector (Circuits 377RF– and 377RF+). Resistance reading below 500 or above 2000 ohms 136 002 02 Intermittent open circuit or incorrect sensor resistance Go to Test 3.
Resistance reading between 500 and 2000 ohms Check the wiring between the ECU and the wheel sensor (Circuits 377RF+ and 377RF–). Repair as necessary. 3. Disconnect the sensor at the sensor connector. Measure the resistance at the sensor connector (on the sensor side). Resistance reading below 500 or above 2000 ohms Replace the wheel sensor. Resistance reading between 500 and 2000 ohms Check for intermittent, loose or poor connections in Circuits 377RF+ and 377RF– and repair as necessary. If the problem persists, suspect the ECU is at fault. 4. Measure the resistance across Pins 4 and 9 of the green X3 ECU connector (Circuits 377RF– and 377RF+).
Resistance reading below 500 or above 2000 ohms Go to Test 5. 136 002 05 Open circuit Resistance reading between 500 and 2000 ohms Check the wiring between the ECU and the wheel sensor (Circuits 377RF+ and 377RF–). Repair as necessary. 5. Disconnect the sensor at the sensor connector. Measure the resistance at the sensor connector (on the sensor side). Resistance reading below 500 or above 2000 ohms Replace the wheel sensor. Table 5, J1587 Fault 136-002 Right Front Wheel Sensor Business Class M2 Workshop Manual, Supplement 4, March 2003 300/12