. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 3. Open engine side cover on the left side of machine. 4. Set the container to catch the fuel under the filter cartridge (2). 5. Using a filter wrench, turn filter cartridge (2) counterclockwise on remove it. NOTICE Do not fill the new filter cartridge with fuel. Remove cap (B) and install the filter cartridge. 6. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. 4 - 66 7. When installing, tighten until the packing surface contacts the seal surfa ce of the filter holder, then tighten it of a turn.
If the filter cartridge is tightened too far, the packing will be damaged a filter cartridge is too loose, fuel will also leak from the packing, so alwa nd this will lead to leakage of fuel. If ys tighten the correct amount. ollows. st position). 8. Open fuel supply valve (1). 9. After replacing filter cartridge (2), bleed the air from the fuel circuit as f 10. Fill the fuel tank with fuel (to the position where the float is at the highe 11. Loosen the knob of feed pump (3), pull it out, then pump it in and out until it becomes heavy. REMARK There is no need to remove the plugs from the fuel pre-filter head and fuel main filter head.
If the engine runs out of fuel, operate feed pump (3) in the same way to bleed the air. 12. After completing the air bleeding operation, push in the knob of feed pump (3) and tighten it. utes at low idling. 13. After replacing the filter cartridge, start the engine and run it for 10 min Check that there is no leakage of fuel from the filter seal surface and th any leakage of fuel is found, check that the filter cartridge is tightened pro 1 - 5 to remove the filter cartridge, then check the packing surface for da is found, replace the cartridge with a new part, then repeat Steps 6 - 1 e transparent cap mounting surfac perly. If the fuel still leaks, repeat St mage or embedded dirt.
If any prob 2 to install the new cartridge.