HYDRAULIC SYSTEM WARM-UP WARNING! If a problem or abnormal operation occurs, immediately shut down engine. Allow excavator to reach normal operating temperature before starting work, especially in cold weather. The correct operating temperature of the hydraulic oil is 50° – 80°C (120° – 175°F). Make sure to follow the procedures listed below for hydraulic fluid warm-up. 1. Run engine for approximately 5 minutes set at the middle of the speed range, without a load. HAOB410L Figure 14 2. Set safety lever (1, Figure 15) on "UNLOCK" position. 1 ARO0450L 3. Slowly cycle boom, arm and bucket cylinders about five times without a load to circulate the oil through the system. Do this for 5 minutes.
Figure 15 4. Check for clearance and fully raise the front attachment. Swing clockwise 3 revolutions. Swing counterclockwise 3 revolutions. 5. Travel forward and reverse at low speed for two revolutions of the drive sprocket. ARO0470L Figure 16 3-10 Operation 022-00058E Operation and Maintenance Manual