daewoo Solar 140LC-V — Travel Control Lever Operation

7. If dirt or mud builds up in the track frame, raise each track and rotate and clean that track. CAUTION! When using the boom and arm to lift any portion of the machine, roll the bucket until the round base is against the ground. The angle of the arm to the boom should be at 90°. Make sure that the material build-up has been cleared. See Figure 36 and Figure 37. Figure 36 8. The excavator can travel in water that comes up to the top of the upper carriage rollers. Make sure that footing is solid so that the machine will not sink. See “Working in Water” on page 3-29. NOTE:

If the machine is submerged to the point that water or mud gets into the swing bearing or center joint, stop machine operation. Remove the machine from the submerged location to firm, dry ground. Do not operate until proper inspection and maintenance have been completed. Refer to the Shop Manual or contact your distributor. HAOB590L Figure 37 TRAVEL CONTROL LEVER OPERATION 1. To travel straight (Figure 38), push both travel control levers/pedals fully forward or backwards. The farther the levers/pedals are pressed, the faster the travel speed. NOTE: "X" is the sprocket end of the track. "X" Figure 38 ARO0801L 3-18 Operation 022-00058E Operation and Maintenance Manual