4-52 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual BOLT AND NUT INSPECTION Inspect ALL fasteners after the first 50 hours of operation or rebuild, and every 250 hours thereafter. If any are loose or are missing tighten them or install new hardware. Always use a calibrated torque wrench. IMPORTANT Always clean fasteners before tightening. If counterweight is loose, contact a DAEWOO distributor or sales agent. . No. Point To Be Inspected Bolt Dia. mm Qty.
Bolt Head Size Torque kg•m N•m ft lb 1 Joint bolt with engine mounting bracket and engine pump side 12 8 19 9 88 65 fan side 10 8 17 5 49 36 2 Joint bolt & nut between engine mounting bracket and frame pump side 20 2 30 46 451 333 fan side 20 2 30 46 451 333 3 Radiator mounting bolt 16 4 24 27 265 195 4 Tightening bolt for hydraulic oil tank 16 4 24 21 205 152 5 Tightening bolt for fuel tank 16 4 24 21 205 152 6 Tightening bolt for pump 16 4 S 24 235 174 7 Tightening bolt for control valve 12 4 19 9 88 65 8 Tightening bolt for swing reduction device 16 9 24 27 265 195 9 Tightening bolt for swing motor 12 10 S 14.4 141 105 10 Tightening bolt for battery 10 4 17 5 49 36 11 Joint bolt with cab mounting rubber and frame 10 16 17 6.7 66 48 Joint bolt with cab mounting rubber and cab 16 4 24 21 206 152 12 Joint bolt with swing bearing and upper frame 20 35 30 55 539 398 Joint bolt with swing bearing and bottom frame 20 36 30 55 539 398 13 Tightening bolt for travel reduction device 16 40 24 27 265 195 Tightening bolt for sprocket 16 30 24 27 265 195 14 Tightening bolt for upper roller 12 8 19 9 88 65 15 Tightening bolt for bottom roller 16 56 24 27 265 195