daewoo Solar 140LC-V — Track Tension

4. The increased clearance recommended for muddy ground conditions is between 340 - 380 mm (13.39 - 15.0 in). The clearance should be approximately 380 mm (15.0 in) for operation over gravel, rocky terrain, or over sand or snow. WARNING! The track adjusting mechanism is under very high-pressure. NEVER release pressure too suddenly. The grease cylinder valve should never be backed off more than 1 complete turn from the fully tightened down position. Bleed off pressure slowly and keep your body away from the valve at all times. 5. Track tension adjustments are made through the grease fitting (1, Figure 98) in the middle of each side-frame.

Adding grease increases the length of an adjustment cylinder (2). The longer the adjustment cylinder, the greater the pressure on the tension spring pushing the track idler wheel outward. 2 3 6. If there is not enough slack or clearance in the tracks and the adjustment is too tight, the idler wheel and adjusting cylinder can be retracted by bleeding off grease through hole in adjustment cylinder (2, Figure 98) by loosening valve slowly (3, Figure 98). 1 ARO1730L Figure 98 WARNING! Do not loosen or remove the grease fitting (1, Figure 98) until the pressure is entirely bleed off by loosening valve (3, Figure 98) slowly.

4-70 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual