daewoo Solar 140LC-V — 2. Engine Speed Control Dial

1. STARTER SWITCH A four-position starter switch is used to start or shut down engine for equipment operation. O. Turning the switch to this position turns the engine "OFF" along with its electrical system. In this position the engine is "OFF" but the interior cab light and fuel tank transfer pump (if equipped) are functional. I. Turning the switch to this position turns the engine electrical system "ON." The charge indicator light and the oil pressure warning light should be "ON" at this time. HAOC340L Figure 4 . Moving switch to this position will crank engine. When engine starts, release key and allow it to return to "I" (ON) position.

Do not operate the starter switch for more than 15 seconds at a time. This will help prevent damage to starter. WARNING! DO NOT USE STARTING FLUIDS. The preheat system could cause the starting fluid to explode. Starting fluids should never be used. . Preheat position. Used to aid engine starting in cold weather. When key is in this position, engine preheater is operating. When preheat indicator light turns "ON" engine preheat cycle is complete. Immediately turn key to crank position and start engine. 2. ENGINE SPEED CONTROL DIAL The engine speed is controlled by the dial. Rotating it clockwise increases engine speed (rpm) and counterclockwise decreases engine speed.

A Low idle (Lowest engine speed) B High idle (Highest engine speed) NOTE: The auto idle system will automatically reduce engine speed to idle speed approximately 4 seconds after all of the control levers are in the neutral position. This system is designed to reduce fuel consumption and noise. See “3. Auto Idle Selector Button” on page 2-24. HAOA690L Figure 5 2-6 Operating Controls 022-00058E Operation and Maintenance Manual