2. WORK MODE SELECTOR BUTTON The work mode selector button is used to control wether the excavator is operated in "Digging Mode" or "Trenching Mode." When the work mode button is pushed to the "ON" position, an indicator light above it turns "ON," and "Trenching Mode" is activated. This mode is suitable for a smooth trench or smooth trench wall. When the work mode button is pushed again, it is turned "OFF" and the trenching mode is deactivated and the excavator returns to the "Digging Mode." ARO0270L Figure 48 NOTE: When you turn the engine starter switch to the "I" (ON) position, the work mode is automatically defaulted to "Digging Mode." NOTE:
When setting the main menu, this button is used to function as the change (DOWN: ) button. For further details, see "Mode Selection." 3. AUTO IDLE SELECTOR BUTTON When the auto idle system is activated, the engine will automatically reduce speed to "IDLE" approximately 4 seconds after all of the control levers are in the neutral position. This system is designed to reduce fuel consumption and noise.
When the auto idle selector button is pushed to the "ON" position, an indicator light above it turns "ON." When the auto idle selector button is pushed again, it is turned "OFF" and the engine speed will return to the setting of the engine speed dial and will remain at this speed despite control lever position, until the engine speed dial is moved. ARO0280L Figure 49 NOTE: When setting the main menu, this button is used to function as the select (ENTER: ) button. For further details, see "Mode Selection." 2-24 Operating Controls 022-00058E Operation and Maintenance Manual