O-Ring Application Charts Caterpillar offers O-Rings made from various materials. The following tables provide general guidelines to follow when matching O-Ring materials with applications. Caterpillar's standard material offering, unless otherwise noted, is the Nitrile 90.
Common Uses MATERIAL DUROMETER FINAL DRIVE ENGINE ENGINE HYDRAULIC FUELS POWER HYDROSTATIC TYPE & LUBE COOLING SYSTEMS (DIESEL SHIFT TRANSMISSIONS HARDNESS DIFFERENTIALS OILS SYSTEMS & GAS) TRANSMISSIONS NITRILE (BUNA N) 75 X X X X X X X NITRILE (BUNA N) 90 X SILICONE 70 X X X X** X EPDM 70 X FLUOROELASTOMER (VITON) 75 X X X X X FLUOROELASTOMER (VITON) 90 X X X X X ** Limited Use Material and Application Descriptions MATERIAL DUROMETER TEMPERATURE INTERMITTENT APPLICATION TYPE RANGES HIGH TEMP.
DESCRIPTION HARDNESS OPERATION NITRILE (BUNA N) 75 -40° to 107°C (-40° to 225° F) 121°C (250°F) Good for use in all oil applications including lubricating and hydraulic oils, gasoline, alcohol, 90 -34° to 107°C (-30° to 225°F) 121°C (250°F) water and alkaline and salt solutions. In hydraulic systems, use 75 Durometer A Hardness in pressure applications 90 Durometer A Hardness in pressure applications =>1500 psia. SILICONE 70 -53° to 163°C (-65° to 325°F) 232°C (450°F) For use in high heat/low pressure applications on or near engines, transmissions, and hydraulic systems. Good with engine and hydraulic oils, but not fuels or gasoline.
Relatively weak physical strength and abrasion resistance usually limit silicones to static service. Do not use silicone or grease as a lubricant on a silicone seal. EPDM 70 -54° to 177°C (-65° to 350°F) Primarily used for sealing engine cylinder liners and occasionally used to seal cooling and air inlet systems. Excellent resistance to water, steam, acid, ketones, phosphate esters, automotive brake fluids and ozone; not recommended for use with petroleum oils. Because EPDM swells when in contact with oil or fuel, liquid soap or glycerine is usually used on the seal during assembly.
FLUOROELASTOMER 75 -40° to 200°C (-40° to 400°F) 260°C (500°F) For use with petroleum oils and silicone greases. (VITON) Do not use with ketones, methoxypropanol based 90 -25° to 200°C (-15° to 400°F) 260°C (500°F) coolants (Dowtherm 209) or anhydrous ammonia. Provides high temperature stability and exhibits extended life over 120°C (248°F). Use 75 Durometer A Hardness with pressures and 90 Durometer A Hardness with pressures => 1500 psia. 154