XT-5 Hose CATERPILLAR XT-5 ® XT-5 Hose (1036)** Exceeds the requirements of SAE 100R13. MIN. MAX. MIN. HOSE HOSE HOSE BURST WORK. BEND PART I.D. DASH O.D. PRESS. PRESS. RADIUS* NUMBER (in) (mm) SIZE (in) (mm) (psi) (kPa) (psi) (kPa) (in) (mm) 5P0200 0.750 19.1 -12 1.26 32.1 20,000 140,000 5,000 35,000 9.49 241 5P0201 1.000 25.4 -16 1.52 38.7 20,000 140,000 5,000 35,000 12.01 305 5P0202 1.250 31.8 -20 1.96 49.8 20,000 140,000 5,000 35,000 16.50 419 5P0203 1.500 38.1 -24 2.26 57.3 20,000 140,000 5,000 35,000 20.00 508 5P8358 2.000 50.8 -32 2.80 71.1 20,000 140,000 5,000 35,000 25.00 635 Construction:
Fabric reinforced, synthetic rubber tube; four or six piles of spirally-wrapped high tensile steel wire reinforcement, separated by layers of synthetic rubber. Oil, weather, and abrasion resistant synthetic rubber outer cover. Application: Very high pressure service with petroleum base hydraulic fluids. MSHA approved cover. Temperature Range: -40° F to +250° F (-40° C to +121° C) Couplings: Collet-type reusable, skive type - pages 63-71 . Crimp-on permanent, skive type - page 72-74 . For related assembly equipment and tooling, see pages 277 - 310 . NOTE: Hose cover needs to be removed before attaching couplings. * CENTERLINE OF HOSE ** SOLD BY THE CENTIMETER 2 warning!
TO AVOID SERIOUS PERSONAL INJURY TO THE OPERATOR AND EXTENSIVE DAMAGE TO THE EQUIPMENT, THE FOLLOWING PROCEDURES MUST BE OBSERVED. FAILURE TO DO SO COULD RESULT IN PERSONAL INJURY. 1 ALWAYS match hose, stem assemblies and sleeves according to markings ( / + / UHP ). NEVER interchange XT-3 hose, stem assemblies and sleeves marked with a triangle ( ) with XT-5 hose, stem assemblies and sleeves marked with a plus ( + ) or XT-6 hose, stem assemblies and sleeves marked with UHP . UHP UHP XT-3 HOSE XT-5 HOSE XT-6 HOSE 62 XT-5 Hose Couplings Features (C) Extruded Head Stem and Collet • More uniform strength for longer coupling and Benefits assembly life.
XT-5 Hose Couplings have the same advantages (D) Precision Machined Rectangular Ring Head as XT-3 Hose Couplings as well as these added • Positive high-pressure seal. features for 5000 psi (35,000 kPa) application: (A) Stem Construction • Heavier for greater durability. (B) Finger and Stem • Longer for extra grip and superior coupling retention. UHP