. OPERATION EXPLANATION OF COMPONENTS goes down, set to the goes up, set to the 3 - 67 TEMPERATURE CONTROL SWITCH Use this switch (7) to adjust the temperat ure of the air blowing out from the ve nts. The ad justment can be made to 8 levels f rom low temperature to high tem perature. The tem perature of the air blowing out fro m the vents is displayed on temperature bar (D) o n the monitor . The lower the num ber of segments lighted up on th e bar, the lower the temperature is. Press th e > switch to raise the temperatu re; press the emperature. Even wh en the starting switch is turned O FF, the settings of each mode are r etained in memory.
How ever, in the following cases, the settings must be ma de again. rence from outside When there has been abnormal interfe METHOD OF OPERATION With the FACE vents, it is possible to adj ust the direction of the air flow and t o turn it on However , do not set to the FACE mode w ith the vents closed. COOLIN G 1. Pres 2. Pres 3. Pres 4. Pres 5. Pres 6. Pres 7. Whe desir s ON/OFF switch (1) to turn on t s fan switch (2) to set the air flow s temperature control switch (3) t s air conditioner switch (4) to set s FRESH/RECIRC selector swit s mode selector switch (6) to set n the temperature inside the ca ed temperature and air flow.
NOTICE If operatio ns are continued for a long time wit h the air conditioner set to the lowest te mperature an d minimum air flow, there is danger th at the receiver drier may freeze. If it freeze s and no cold air comes out, stop usi ng the cooling, and set to a higher tempe rature and th e maximum air f low. Run for a short ti me under these conditions, then retu rn to the cooling operation. HEATING 1. Pres 2. Pres 3. Pres 4. Pres 5. Pres 6. Whe desir s ON/OFF switch (1) to turn on t s fan switch (2) to set the air flow s temperature control switch (3) t s FRESH/RECIRC selector swit s mode selector switch (5) to set n the temperature inside the c ed temperature and air flow.