. OPERATION OPERATION CAB TILT OPERATION WARNING 3 - 109 To prevent se rious injury or death if the cab comes do wn, always observe t he f ollowin g strictly when tilting the cab. Precautions b efore performing cab tilt operation a flat place. Perform th e cab tilt operation on To prevent interferenc e between the cab and machin e body when performing the tilt operation, set the machine facing directly to the front and secure the front and rear frames wit h the articulation lock. Set the par king brake switch to " PARKING" position to apply the parking brake.
Lock the d ump control lever with the dump lever lo Put blocks under the ti res to pre vent the machine fr Do not perf orm the ca b tilt opera tion in the strong w Precautions w hen performing cab ti lt operation Do not ope rate the cab tilt when the machine is load Do not stan d under th e cab durin g the cab tilt opera While the c ab is tilted up, fix it wi th the lock bar sec While the c ab is tilted up, do not ride on or get off it While the c ab is tilted up, do not operate the gear s hift lever or dump contro Do not star t the engine while the cab is tilted up.
If i t is necessary to s tar t the engine when performing inspection, check first that there i s no one under the ca Do not sub ject to the machine to any large impact f orce while the cab is tilte d up. When lowe ring the cab by using the tilt cylinder, do not lower the hydraulic pressure at a time but lower i t gradually to adjust the lowerin g speed of the cab. The lock ba r is set on the right in side of the engine hood. After using it, be s ure to r eturn it.