Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING tightening torque. 3 - 133 It is d angerous to ch arge a battery installed o n a machine. Make sure that it is removed bef ore charging. the engine and turn the When checking or ha ndling the battery, stop starti ng switch key to OFF position. The b attery generates hydrogen gas, so there is a hazard of explosion. Do no cause t bring lighted c igarettes near the batter y, or do nothing that will sparks. Batte ry electrolyte is dilute sulfuric acid, and i t will attack your clothes and s off wi fresh kin. If it gets on your clothes or on your s kin, immediately wash it th a large amou nt of water.

If it gets in yo ur eyes, wash it out with water and cons ult a doctor. When handling batteri es, always wear protectiv e eyeglasses and rubber glove s. When removing the b attery, first disconnect th e cable from the ground (norm (+) ter If a t dang ally the negative (-) terminal). When inst alling, install the positive minal first. ool touches the positive (+) terminal and the chassis, there is se a spark, so be extremely careful. er that it will cau se a spark, so be extrem If the terminals are loo se, there is danger that t he defective contact may gener When ate sparks that will cause an explosion. .

installing the te rminal, securely install it When removing or ins talling the terminals, ch eck which is the positive (+) ter minal and whic h is the negative (-) termi nal. REMOVAL AND INSTALLATION OF B Befo re removing th e battery, remove the ground cable (normall y connected to the negative ( If a t ool touches the positive (+) terminal and the chassis, there is danger that i t will cause a Whe n installing the battery, connect the g Whe n replacing the battery, fix the battery body with the battery nting fixtures. S ecurely tighten the te rminal to the following Tighten ing torque of w iring harness termina :

11.8 t o 19.6 Nm {1.2 to 2.0 kgm, 8.68 to 1 Tighten ing torque of b attery terminal (2) : 9.8 to 11.8 Nm {1.0 t o 1.2 kgm, 7.23 to 8.6 Tighten ing torque of 1 st nut (3) of mounting : 7 to 9 Nm {0.71 to 0. 92 kgm, 5.14 to 6.65 l Tighten ing torque of 2 nd nut (4) of mounting : 35 to 45 Nm {3.57 to 4.59 kgm, 27.1 to 33.