. OPERATION TROUBLESHOOTING a potentiometer that detects the amount that the accelerator pedal is depressed. In addition, there is a switch that judges if the accelerator pedal is being depressed or if it has been released. 3 - 139 IF ACCELERATOR PEDAL HAS FAILED Th e a ccelerator p edal is equip ped wit If it is impossible to detect corre ctly the amount t hat the acc elerator p edal is depres sed because of b reakage of the accelerator pedal o r defective w iring, th e engine controller controls the e ngine in accordance with t he signa l from thi s judgment switc h.
When the accelerator ped al is being depressed, th e engine speed is set to 1 500 rpm; when the accelerator pe dal is release d, the e ngine sp eed is set t o low idle . Th e speed differs according to the load.
Operate the accele rator pedal t o move the mac hine to a sa fe place , then check th e failure code an d contac t your Komatsu distributo When operating th e accelerator pedal, r elease t he pedal to turn it to OFF position ( low idle) or depre ss it fully to set to 1500 r If t he operated REMARK If t he engine contr oller cannot c orrectly receive the signal f or the amoun t that the accelerator peda l is depressed, the centralized war ning lamp wi ll flash, the alarm buzzer wi ll sound, and action co de "E03" will be d isplayed.