. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM FRONT BRAKE WARNING Stop the machine on level ground and put blocks under the wheels before bleeding the air. same as for the slack adjuster (with step 4 excluded). NOTICE The brake oil pressure caution lamp may light on during air bleeding. In that case, tighten the bleeder screw and depress the brake pedal 8 to 10 times to charge pressure to the accumulator. In addition, check sight gauge (H) to see if some oil remains in the brake oil tank. If there is no oil left, stop the engine and add oil. (When the engine stops, the oil level rises and the brake oil tank is automatically refilled with oil.) 7.
After finishing air bleeding, stop the engine (for 2 to 3 minutes), and adjust the oil level so that it reaches the specified level. For details, see "CHECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL (PAGE 3-74)". 4 - 32 To make it easier to bleed the a ir, warm the oil up to a temperature of at least 40°C (104°F) before bleeding the air. Bleed the air from the front bra kes in the same way on both the left and right sides. 1. Start the engine, check tha t the oil in the transmission case is the specified level, and check if the retarder oi pressure caution lamp is o 2. Remove the cap installed adjuster, then insert a vinyl Prepare a container with oi hose approx.
50 mm (2.0 i (Use any commercially ava 3. Depress the brake pedal an 3/4 turns. Keep the pedal come out from the vinyl ho 4. Pull the retarder control le approx. 3/4 turns. Keep th until no more bubbles com 5. After bleeding the air, tighte the cap. 6. The procedure for bleeder