Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) 1. Stop the engine. CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 57 9. When installing, tighte n until the packing surface contacts the seal surface of the filter h ead, then tighte n it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be da maged and this will lead t o leakage of fuel . If the filter cartridge is too lo ose, fuel will also leak from the packing , so always tighten the co When tightening wit h a filter wrench, be extremely careful n ot to dent or damage the 10.

Check that the drain p lug at the bottom of the water separator cup is tightened securely Tightening torque: 0.2 to 0.45 Nm (0.02 to 0.046 kgm, 0.1 to 0 11. After replacing the fue l main filter cartridge (at intervals of 1,0 00 hours), bleed air. For d etails, see "REPLACE FUEL MAIN FILTER C ARTRIDGE (PAGE 4-62)". Do not add fuel to the fuel main filter cartridge, howe ver. 12. Start the engine, chec k that there is no leakage of fuel from th e filter seal surface or wa ter separator mo unting surface, then run for a pproximately 10 minutes at low idle. 2. By using a grease pu mp, pump in grease through the grease fittings shown by arrows. 3.

After greasing, wipe off any old grease that was pushed out. fittings shown by arro 3. After greasing, wipe o Immediately after the engi ne is stopped, its parts and oil are still very h ot, and may cause burn inju ry. Accordingly, wa it until they have cooled down be fore starting the work. If there is still pressure rem aining inside the case, the oil or plug may fly out. Turn the plug slowly to r elease the pressur e, then remove it carefully. 1. Stop the machine so t hat the TOP casting mark is at the top t the bottom. and drain plug (P) is a 2. Remove plug (G) and check that the oil level is near the bottom of the plug hole. 3.

If the oil level is too lo w, add oil through the plug hole until the oil overflows. 4. Repeat the procedure in steps 1 - 3 and check the oil level and add oil to all the final d rive cases (front, center, rear).