. MAINTENANCE SERVICE PROCEDURE EVERY 1000 HOURS SERVICE Maintenance for every 50, 250 and 500 hours should be carried out at the same time. REPLACE FUEL MAIN FILTER CARTRIDGE WARNING 4 - 62 Immediately after the engine is stop ped, the parts are at high temperature. Do not replace the filte r immediately. Wait for the temperature of all parts to go down . he engine fuel piping system when the engine is running. High pressure is generated inside t When replacing the filter, wait for a t least 30 seconds after stopping the engine to let the interna l pressure go down before replacing the filter. .
Do not bring any fire or flame close NOTICE Genuine Komatsu fuel filter cartrid ges use a special filter that has highly efficient filtering ability . When replacing the filter cartridge, always use a genuine Ko matsu part. The common rail fuel injection sys tem used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Ko matsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid using subst itute parts. When performing inspection or ma intenance of the fuel system, pay more attention than normal t o the entry of dirt.
If dirt is stuck to any part, use fuel to wash it off completely. Prepare a filter wrench rtridge, replace the fuel main filter cartridge. ter cartridge to catch the fuel. h, turn filter cartridge (1) t. packing surface of the new filter stall the filter cartridge to the filter artridge. After replacing the fuel prefilter ca 1. Place a container under the fil 2. By using a filter wrenc counterclockwise on remove i 3. Clean the filter head, coat the 1. Place a container under the fil cartridge thinly with oil, then in head. NOTICE Do not add fuel to the fuel main filter c 4.
When installing, tighten until t he packing surface contacts the seal surface of the filter head, then tighten it 3/4 of a turn. If the filter cartridge is tightene filter cartridge is too loose, fue When tightening with a filte d too far, the packing will be damaged and this will lead to leakage of fuel. If the l will also leak from the packing, so always tighten the c r wrench, be extremely careful not to dent or damage th 5. After replacing filter cartridge Do not loosen the plug in the f ilter head of the fuel prefilter. It will become impossible 6. Fill the fuel tank with fuel.