. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING IN CHECK ALTERNATOR, STARTING MOTOR contact your Komatsu distributor for inspection or CHECK WATER PUMP Check around the water pump for water leakage. If any part is leaking, ask your Komatsu distributor for inspection/repair. CHECK AIR COMPRESSOR Ask your Komatsu distributor to perform this work. 4 - 88 EVERY 4000 HOURS SERVICE Maintenance for every 50 , 250, 500, 1000 and 2000 hours serv ice should be carried out at th Immediately after the eng ine is stopped, its parts and oi l are still ver y hot, and may cause burn injury. Accordingly, wait until they have cooled down b efore starting the work.
ler cap, turn it slowly to release the internal pressure, then remove it. When removing the oil fil ler cap, turn it slowly to releas e the internal Refill amount of oil: 18 1. Lower the dump bod y and stop the engine. ller (F) to release the internal pressu cap. t any oil on you, remove drain plug (P ten the plug again. amount of engine oil from oil filler (F). 2. Turn the cap of oil fi before removing the 3. Taking care not to ge drain the oil, then tigh 4. Pour in the specified amount of engine oil from o 5. After adding oil, chec k that the oil is at the specified level. F details of the oil t HYDRAULIC TANK, o use, see "CHECK OI L LEVEL ADD OIL (PAGE 3-74)".
LUBRICATE FAN PUL LEY mp, pump in grease through the grea ws. 1. Stop the engine. 2. By using a grease pu fittings shown by arro 3. After greasing, wipe 1. Stop the engine. off any old grease that was pushed out NOTICE Do not use air pressure or oi l pressure to perform high-pressure greasin The brush may be worn repair. If the engine is started fre quently, perform inspectio n every 100