. SAFETY PRECAUTIONS FOR OPERATION 2 - 24 STARTING WITH BOOSTER CABLES n the method of connecting the booster If any mis take is made i cables, it may cause the battery to explode, so alw ays observe the following. wear safety goggles and rubber gloves when starting ine with booster cable. connecting a normal machine to a failed machine with Always the eng ine with boost When connecting a n booster cables, alway s use a normal machin failed machine. a booster cable, perfo e with the same rm the starting battery voltage as the When starting with operati on with 2 worke rs (1 worker sitting in th e operator's seat and the other working with the battery).
nother machine, do not allow the nomal achine. When starting from a machin e and failed m When c onnecting the booster cables, turn the starting switch to OFF po sition for both the normal machine and failed machine. There i s a hazard that the machine will move w hen the power is connec ted. Be sure to connect the positive (+) cable first w hen installing the booster cables. Disco nnect the negative (-) ca ble (ground side) first wh en removing th em. ooster cables, be careful not to let the When r emoving the b booster cable clips tou ch each other or to let th e clips touch the machin e.
For det ails of the starti ng procedure when usin g booster cables, see "S TARTING EN GINE WITH BOOSTER CABLE (PAGE 3-135)" in the OPERA TION section.