BASIC SERVICE 137 Oil and Filter Change Procedure This engine is equipped with improved spin-on type oil filters. DISPOSABLE SPIN-ON OIL FILTER REPLACEMENT Note: Install new filters dry. Change oil and replace oil filters using the following procedure: 1 Run the engine until normal operating temperature is reached. Then, shut off the engine and drain the oil before the engine cools. 2 Thoroughly clean the area around the filters before removing. 3 Using filter wrench 9998487 or equivalent, remove the spin-on filters and wipe the filter mounting base clean.
4 Apply a film of clean engine oil to the sealing gasket on each new filter.Apply a film of clean engine oil to the sealing gasket on each new filter. 6 Fill the crankcase with the recommended engine oil. 5 Install the filters and tighten 3/4 to 1 turn after the gasket contacts the base. 7 Start the engine and check for leaks. Run the engine for approximately five minutes, then shut it off and recheck the oil level. Add oil if necessary. Note: Use of anything other than genuine Volvo filters may cause damage and void the engine warranty. Change filters according to the recommended maintenance schedule.
Crankcase Ventilation System The crankcase ventilation (CCV) system separator is not repairable. If there is apparently faulty operation, perform these inspections before replacing the separator. 1 Inspect the separator inlet hose and connectors at the valve cover and at the separator. Remove any obstruction, oil film, residue and particles. 2 Inspect the separator outlet hose and connector. Remove any obstruction, oil film, residue and particles. 3 Remove the separator and attempt to turn the turbine manually. If it does not turn easily, replace the separator. 4 If the turbine turns easily, inspect and clean the oil jet nozzle. 5 Reassemble the separator and the hoses.
6 If faulty operation continues, continue fault tracing with Guided Diagnostics.