BASIC SERVICE 161 Inlet Valve Adjustment With the engine cold, 60°C (140°F) or less, check and adjust the valves and injector as required for each cylinder before moving to the next. Follow this sequence of cylinders when adjusting clearances: 5, 3, 6, 2, 4 and 1. 1. Using the flywheel turning tool, 88800014, bar the engine over manually to the appropriate camshaft marking for adjustment of the inlet valves and injector for that cylinder. W2033397 2. Using a feeler gauge, check the clearance between the rocker arm adjusting screw and the valve yoke (bridge) of the inlet valves. 3. If the clearance is not within specification, loosen the locknut and adjust the clearance as required. 4.
Hold the adjusting screw to prevent it from turning and tighten the locknut to specification. 5. Recheck the clearance after tightening the locknut. 6. Mark the respective rocker arm as each adjustment is completed. WARNING Apply the parking brake before barring the engine over. Remove the EMS power supply fuse to avoid starting the engine unintentionally. Make sure that the transmission is not in gear.