volvo — PV776-QRG07-MP8.pdf

BASIC SERVICE 165 1. Loosen the screws holding the plate springs to release the spring tension against the engine brake rocker arms. W2033400 2. Using the flywheel turning tool, 88800014, bar the engine over so that the appropriate E number marking is between the lines on the front camshaft bearing cap. W2033401 3. Measure the clearance between the exhaust rocker arm piston and the shim on top of the valve yoke (bridge). 4. If clearance is not within specification, adjust the clearance as follows, using shims placed on top of the valve yoke (bridge). Adjusting Exhaust Rocker Arm Clearance a. Remove the shim retaining screw and remove the shim(s). b.

Determine the thickness of the shim(s) required to provide the specified clearance. c. Make sure that the valve yoke and shim(s) are clean. Place the shim(s) in position on the valve yoke and install the retaining screw. Tighten the screw to specification. Note: Do NOT use more than two shims. Shims are available in 0.05 mm (0.002 inch) increments with the thickness marked on the surface. If two shims are required to take up the clearance, the shims should be of nearly equal thickness. 5. .Leave the feeler gauge in place between the exhaust rocker arm piston and the valve yoke shim and adjust the brake rocker arm clearance.