Kubota — LUBRICANTS, FUEL AND COOLANT

MAINTENANCE LUBRICANTS, FUEL AND COOLANT LUBRICANTS, FUEL AND COOLANT NOTE : The product name of Kubota genuine UDT fluid may be different from that in the operator's manual depending on countries or territories. Consult your local KUBOTA Dealer for further details. Engine oil The oil used in the engine should have an American Petroleum Institute (API) service classification and proper SAE engine oil according to the ambient temperatures shown in the previous table. Refer to the following table for the suitable API classification engine oil according to the diesel particulate filter (DPF) type engines and the fuel.

Fuel Use the ultra low sulfur diesel fuel only (below 0.0015% or 15 ppm) for these engines. Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures below -20 or elevations above 1500 m. 102 M5091N, M5101N No. Locations Capacities Lubricants M5091N M5101N 1 Fuel 76 L No.2-D S15 diesel fuel No.1-D S15 diesel fuel if temperature is below -10 ℃ 2 Coolant 10 L (Recovery tank: 1.0 L) Fresh clean soft water with antifreeze 3 Washer liquid 2 L Automobile washer liquid 4 Engine crankcase (with filter) 10.7 L • Engine oil:

API service classifica- tion CJ-4 (DPF type engine) Above 25 ℃ SAE30, SAE10W-30 or 15W-40 -10 ℃ to 25 ℃ SAE10W-30 or 15W-40 Below -10 ℃ SAE10W-30 5 Transmission case 52 L • KUBOTA UDT or SUPER UDT fluid* 6 Front differential case oil (4WD) 5 L • KUBOTA UDT or SUPER UDT fluid* or SAE 80 - SAE 90 gear oil 7 Front axle gear case oil (4WD) 3 L 8 Greasing No. of greasing points Capacity Type of grease Top link 2 Until grease overflows.

Multipurpose grease NLGI-2 or NLGI-1 (GC-LB) Top link bracket 2 Lift rod 2 Hydraulic lift cylinder pin 4 Front axle gear case sup- port (4WD) 2 Front axle support 2 Steering joint shaft 1 Battery terminal 2 A small amount Fuel used Engine oil classification (API classification) Oil class for engines with DPF Ultra low sulfur fuel CJ-4