PERIODIC SERVICE DAILY CHECK 4. Bleed the fuel system. (See SERVICE AS REQUIRED on page 130.) (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range. (1) Red float (2) Fuel shutoff-valve (3) Air plug (4) Cup (5) Drain plug (A) [ON] (B) [OFF] (C) (D) “UPPER LIMIT” (E) “WATER” IMPORTANT : When using an oil of different manufacturer or viscosity from the previous one, remove all of the old oil. Never mix 2 different types of oil. If the oil level is low, do not run the engine. IMPORTANT : If water is drawn through to the fuel pump, extensive damage will occur. NOTE :
At times, a small amount of fuel, which is used to regenerate the DPF, may get mixed with the engine oil and the engine oil may increase in volume. NOTE : When the red float reaches near the upper limit level, start from step 2 in the above procedure to drain water from the water separator. 5. Checking transmission fluid level 4. Checking engine oil level 1. Park the machine on a flat surface, lower the implement and shut off the engine. WARNING To avoid personal injury or death: Be sure to stop the engine before checking the oil level. 1. Park the machine on a flat surface. 2. Check engine oil before starting the engine or 5 minutes or more after the engine has stopped. 3.
To check the oil level, draw out the dipstick, wipe it clean, replace it, and draw it out again. Check to see that the oil level lies between the 2 notches. If the level is too low, add new oil to the prescribed level at the oil inlet. (See LUBRICANTS, FUEL AND COOLANT on page 102.) 106 M5091N, M5101N