EVERY 3000 HOURS PERIODIC SERVICE 2. Before employing LLC-mixed cooling water, fill the radiator with fresh water and empty it again. Repeat this procedure 2 or 3 times to clean up the inside. 3. Mixing the LLC Premix 50% LLC with 50% clean soft water. When mixing, stir it up well, and then pour it into the radiator. 4. The procedure for the mixing of water and antifreeze differs according to the make of the antifreeze and the ambient temperature. Refer to SAE J1034 standard, more specifically also to SAE J814c. 3. Checking intake air heater Consult your local KUBOTA Dealer for this service. 4. Checking and cleaning EGR system Consult your local KUBOTA Dealer for this service. 5.
Cleaning DPF muffler 1. Remove the ash. The longer the DPF operates, the more ash (burnt residue) is collected in the filter. Too much ash build-up adversely affects the DPF performance. Consult your local KUBOTA Dealer to clean the filter. *1 At 1.013 x 10 5 Pa (760 mmHg) pressure (atmospheric). A high- er boiling point is obtained by using a radiator pressure cap which permits the development of pressure within the cooling system. IMPORTANT : The DPF needs to be cleaned with a specific cleaning device. Do not disassemble the DPF for cleaning or attempt to clean it yourself. Consult your local KUBOTA Dealer. 5. Adding the LLC a. Add only water if the mixture level is reduced by evaporation.
b. If there is a mixture leak, add LLC of the same manufacturer and type in the same mixture percentage. EVERY 1 YEAR 1. Checking CAB isolation cushion Check the cushion for any breakage or fatigue. Replace them if they have deteriorated. IMPORTANT : Never add any long-life coolant from a different manufacturer. Different brands may have different additive components, and the engine may fail to perform as specified. 2. Checking DPF differential pressure sensor pipe 6. When the LLC is mixed, do not employ any radiator cleaning agent. The LLC contains anticorrosive agent. If mixed with the cleaning agent, sludge may build up, adversely affecting the engine parts. 7.
Kubota's genuine long-life coolant has a service life of 2 years. Be sure to change the coolant every 2000 hours or every 2 years, whichever comes first. Consult your local KUBOTA Dealer for this service. 3. Checking EGR pipe Consult your local KUBOTA Dealer for this service. EVERY 2 YEARS NOTE : The above data represents industry standards that necessitate a minimum glycol content in the concentrated antifreeze. 1. Replacing boost sensor hose Consult your local KUBOTA Dealer for this service. 2. Replacing DPF differential pressure sensor hose EVERY 3000 HOURS 1. Checking turbocharger Consult your local KUBOTA Dealer for this service. Consult your local KUBOTA Dealer for this service. 3.
Replacing EGR cooler hose 2. Checking supply pump Consult your local KUBOTA Dealer for this service. Consult your local KUBOTA Dealer for this service. M5091N, M5101N 129 Vol % antifreeze Freezing point Boiling point *1 ℃ ℃ 50 -37 108