Kubota — 7. Replacing headlamp

SERVICE AS REQUIRED PERIODIC SERVICE (1) Fuse box (2) Bolt (3) Bolt fixed slow-blow fuse (4) Non bolt fixed slow-blow fuse 6. Replacing light bulb 7. Replacing headlamp CAUTION To avoid personal injury: Be careful not to drop the bulb, hit anything against the lamp, apply excess force, or get the lamp scratched. If broken, glass may cause injury. Pay more attention to halogen lamps in particular, which have high pressure inside. Before replacing the lamp, be sure to turn off the light and wait until the bulb cools down; otherwise, you may get burned. 5.1 Replacement procedure Non bolt fixed slow-blow fuse: 1. Disconnect the negative cord of the battery. 2.

Pull out the fuse from the fuse box. 3. Replace with a new one of the same capacity. Bolt fixed slow-blow fuse: Consult your local KUBOTA Dealer for this service. 1. While pushing the right and left lock buttons, pull and remove the electrical connector. 2. Remove the rubber boot. 3. Remove the clamping fixture and then remove the bulb. M5091N, M5101N 133 Light Capacity Headlight 12 V, 55 / 60 W (H4) Hazard light 12 V, 21 W Direction indicator 12 V, 21 W Brake stop light and tail light 12 V, 21 W / 5 W Work light (for outer roof) 12 V, 55 W Front work light 12 V, 35 W Dome light (room lamp) 12 V, 5 W Registration plate light 12 V, 10 W No.

Capacity Protected circuit Type (1) 120 A Engine preheat Bolt fixed (2) 30 A Work light (3) 30 A Electrical outlet Non bolt fixed (4) 50 A Starter, air conditioner (5) 50 A Head lamp, hazard Bolt fixed (6) 30 A Main key switch (7) 140 A Charge