Kubota — REMOVING THE TRACTOR FROM STORAGE

STORAGE TRACTOR STORAGE STORAGE WARNING To avoid personal injury or death: Do not clean the machine while the engine is running. To avoid the danger of exhaust fume poisoning, do not operate the engine indoors without proper ventilation. When storing, remove the key from the key switch to prevent unauthorized persons from operating the tractor and getting injured. IMPORTANT : When washing the tractor, be sure to stop the engine. Allow sufficient time for the engine to cool down before washing. Cover the tractor after the muffler and the engine have cooled down. REMOVING THE TRACTOR FROM STORAGE 1. Check the tire air pressure and inflate the tires if needed. 2.

Jack the tractor up and remove the support blocks from under the front and rear axles. 3. Install the battery. Before installing the battery, be sure it is fully charged. 4. Check the fan belt tension. 5. Check all fluid levels (engine oil, transmission and hydraulic oil, engine coolant, and any attached implements). 6. Start the engine. Observe all gauges. If all the gauges are functioning properly and have normal readings, move the tractor outside. Once outside, park the tractor and let the engine idle for at least 5 minutes. Shut the engine off and walk around the tractor and make a visual inspection looking for evidence of oil or water leaks. 7.

With the engine fully warmed up, release both parking brakes and test the brakes for proper adjustment as you move forward. Adjust the brakes as necessary. TRACTOR STORAGE If you intend to store your tractor for an extended period of time, follow the procedures outlined below. These procedures will ensure that the tractor is ready to operate with minimum preparation when it is removed from storage. 1. Check the bolts and nuts for looseness and tighten if necessary. 2. Apply grease to tractor areas where bare metal will rust, and also to pivot areas. 3. Detach the weights from the tractor body. 4. Inflate the tires to a pressure a little higher than usual. 5.

Change the engine oil and run the engine to circulate oil throughout the engine block and internal moving parts for about 5 minutes. 6. Keep the PTO clutch control switch or lever at “DISENGAGE” position while tractor is stored for a long period of time. 7. With all implements lowered to the ground, coat any exposed hydraulic cylinder piston rods with grease. 8. Remove the battery from the tractor. Store the battery following the battery storage procedures. (See Checking battery condition on page 116.) 9. Keep the tractor in a dry place where the tractor is sheltered from the elements. Cover the tractor. 10.

Store the tractor indoors in a dry area that is protected from sunlight and excessive heat. If the tractor must be stored outdoors, cover it with a waterproof tarpaulin. Jack the tractor up and place blocks under the front and rear axles so that all 4 tires are off the ground. Keep the tires out of direct sunlight and extreme heat. 136 M5091N, M5101N