STARTING THE ENGINE OPERATING THE ENGINE 6. Insert the key into the key switch and turn it . If the ambient temperature is below 0 and the engine is very cold, turn the key to position and hold it until the heater indicator turns off. If the engine fails to start after 10 seconds, turn off the key for 30 seconds. Then repeat steps 6 through 9. To protect the battery and the starter, make sure that the starter is not continuously turned for more than 10 seconds. 10. Check to see that all the indicators on the Easy Checker are . If an indicator is still on, immediately stop the engine and determine the cause. 11. Release the clutch pedal. 1. Checking Easy Checker indicators IMPORTANT :
Daily checks with the Easy Checker only, are not sufficient. Never fail to conduct daily checks carefully by referring to the daily check. (See DAILY CHECK on page 31.) “OFF” (Engine-stop) “ACC” (Electrical power-accessories) “ON” (Engine-run) “START” (Engine-start) NOTE : Some of the Easy Checker indicators may illuminate or start flashing depending on the positions of the levers and switches. 1. When the key is turned , the electrical charge warning indicator and the engine oil pressure warning indicator should come on. If trouble should occur at any location while the engine is running, the indicator corresponding to problem will turn . 2.
Suppose that the engine coolant temperature is not high enough yet. The heater indicator also turns when the key is turned to preheat the engine and goes off automatically when preheat is completed. Illumination time of indicator varies according to the temperature of coolant. 3. The PTO clutch indicator (1) Heater indicator NOTE : The accessories can be used while the engine is stopped. Do not leave the key at position. The battery will be quickly discharged. Turn it back to after use. comes on while the PTO clutch control switch is engaged ( ) and goes off when disengaged. 4. If the fuel level indicator 7. Check the Easy Checker indicators.
(See Checking Easy Checker indicators on page 41.) 8. Fully depress the clutch pedal. 9. Turn the key to “START” position and release when the engine starts. lights up, the fuel level is very low. Add fuel and the indicator will turn off. 5. If the water separator indicator lights up, the water in the water separator is very high. Drain the water and the indicator will turn off. IMPORTANT : Because of the safety devices, the engine will not start except when the PTO clutch control switch is placed in the position and the shuttle shift lever is placed in the “NEUTRAL” position. M5091N, M5101N 41