OPERATING THE TRACTOR OPERATING NEW TRACTOR OPERATING THE TRACTOR OPERATING NEW TRACTOR Face the tractor when getting into or out of the tractor. Do not use the controls as handholds to prevent inadvertent machine movements. Always keep steps and floor clean to avoid slippery conditions. How a new tractor is handled and maintained determines the life of the tractor. A new tractor just off the factory production line has been, of course, tested, but the various parts are not accustomed to each other, so care should be taken to operate the tractor for the first 50 hours at a slower speed and avoid excessive work or operation until the various parts become “broken-in” .
The manner in which the tractor is handled during the “breaking-in” period greatly affects the life of your tractor. Therefore, to obtain the maximum performance and the longest life of the tractor, it is very important to properly break-in your tractor. In handling a new tractor, the following precautions should be observed. 1. Do not operate the tractor at full speed for the first 50 hours Do not start quickly nor apply the brakes suddenly. In winter, operate the tractor after fully warming up the engine. Do not run the engine at speeds faster than necessary. On rough roads, slow down to suitable speeds. Do not operate the tractor at high speed.
The above precautions are not limited only to new tractors, but to all tractors. However, they should be especially observed in the case of new tractors. STARTING THE TRACTOR 1. Adjusting the operator's position. NOTE : The seat and suspension should be adjusted to ensure that the controls are comfortably at hand for the operator, ensuring that the operator maintains a good posture and minimizes risks from whole body vibration. Operator's seat on page 45 Seat belt on page 45 Tilt steering adjustment on page 45 2. Selecting light switch position. Light switch on page 46 Turn signal switch and hazard light switch on page 46 With trailer connector on page 47 3. Checking the brake pedal.
Brake pedals (right and left) on page 47 4. Pull the position control lever to raise the implement. Position control on page 78 2. Changing lubricating oil for new tractors The lubricating oil is especially important in the case of a new tractor. The various parts are not “broken-in” and are not accustomed to each other. Small metal grit may develop during the operation of the tractor, and this may wear out or damage the parts. Therefore, care should be taken to change the lubricating oil a little earlier than would ordinarily be required. For more details, read the maintenance section of this manual.
(See MAINTENANCE on page 99.) BOARDING AND LEAVING THE TRACTOR Never try to get on or off a moving tractor or jump off the tractor to exit. 44 M5091N, M5101N