TIRES, WHEELS AND BALLAST WHEEL ADJUSTMENT 2. Front wheels-4WD Front tread width can be adjusted as shown with the standard equipped tires. To change the tread width: 1. Remove the wheel rim and disk mounting bolts. 2. Change the position of the rim and tire to the desired position, and tighten the bolts. 3. Adjust the toe-in as 2 to 8 mm. (See Adjusting toe-in on page 118.) (See MAINTENANCE on page 99.) IMPORTANT : Always attach wheels as shown in the drawing. If not attached as illustrated, transmission parts may be damaged.
When re-fitting or adjusting a wheel, tighten the bolts to the following torques then recheck after driving the tractor 200 m and 10 times of shuttle movement by 5 m, and thereafter according to service interval. (1) 168 to 199 N m / 17.1 to 20.0 kgf m 86 M5091N, M5101N (1) Tread (1) Tread (1) Tread (1) Tread (1) Tread 7.5R16 --- --- --- --- 1071 mm 250/80-16 --- --- --- --- 1045 mm 260/70R16 1162 mm --- --- --- 1138 mm 280/70R16 1161 mm --- --- --- 1137 mm 7.5-18 --- --- --- --- 1089 mm 250/80-18 --- 1140 mm 1154 mm 1109 mm --- 280/70R18 --- 1140 mm 1155 mm 1109 mm --- 7.5R20 --- 1165 mm --- --- ---