TIRES, WHEELS AND BALLAST WHEEL ADJUSTMENT 3. Rear wheels Rear tread width can be adjusted as shown with the standard equipped tires. To change the tread width 1. Remove the wheel rim and/or disk mounting bolts. 2. Change the position of the rim and/or disk (right and left) to the desired position, and tighten the bolts. IMPORTANT : Always attach wheels as shown in the drawing. If not attached as illustrated, transmission parts may be damaged. When re-fitting or adjusting a wheel, tighten the bolts to the following torques then recheck after driving the tractor 200 m and 10 times of shuttle movement by 5 m, and thereafter according to service interval.
(See MAINTENANCE on page 99.) (1) 260 to 304 N m / 26.5 to 31.0 kgf m (2) 343 to 401 N m / 35.0 to 41.0 kgf m 88 M5091N, M5101N (1) Tread (1) Tread (1) Tread (1) Tread (1) Tread 320/85R24 1385 mm 1276 mm 1332 mm 1223 mm 985 mm 380/70R24 --- 1343 mm 1265 mm 1156 mm 1052 mm 360/70R24 --- 1276 mm 1332 mm 1223 mm 985 mm 440/65R24 --- --- 1216 mm 1107 mm 1101 mm 230/95R32 --- 1350 mm 1262 mm 1212 mm 1000 mm 320/85R28 --- 1359 mm 1255 mm 1151 mm 1063 mm 340/85R28 --- 1354 mm 1264 mm 1151 mm --- 380/70R28 --- --- 1264 mm 1151 mm --- 360/70R28 --- 1359 mm 1255 mm 1151 mm 1063 mm 440/65R28 --- --- --- 1143 mm 1069 mm 230/95R36 --- 1374 mm 1242 mm 1188 mm ---