Kubota — Idler Roller Bearings

SK800 Operator’s Manual Maintenance - 75 p Idler Roller Bearings Check idler roller bearings (shown) at 50 hours and every 300 hours thereafter. Adjust as needed. Check 1. Lift machine. 2. Release track tension. See “Track Tension” on page 78. 3. Check for movement of each hub when rocked back and forth. If hub has noticeable movement, adjust. 4. Adjust track tension. Adjust 1. Remove dust cap cover (1). 2. Ensure bearings are properly seated by tightening castle nut (2) to 30-40ft•lb (41- 54N•m) while turning hub (3). NOTICE: Do not move hub after this step is complete. 3. Loosen and then hand-tighten castle nut. 4. Insert cotter pin into wheel spindle (5). NOTICE:

If hole is visible in slot but cotter pin cannot be inserted, slightly loosen or tighten castle nut to align slot with hole and insert cotter pin. If hole is not visible in slot, loosen to next available slot and insert cotter pin. 5. Bend legs of cotter pin over top of spindle. IMPORTANT: Hub should not have noticeable movement when rocked back and forth. 6. Clean lip seal on bearing cap, apply Loctite® 242 and install cap. 7. Adjust track tension. Procedures t53om024w20.eps 4 1 3 5 2 t43om028w.eps t53om024w20.eps 4 1 3 5 2 t43om028w.eps