Komatsu — CONTROL LEVERS, PEDALS

. OPERATION EXPLANATION OF COMPONENTS INCHING PEDAL CAUTION REMARK It is not necessary to operate the inching pedal when shifting gears. When making gear shifts, operate the gear shift lever, not depressing the inching pedal. The duration of inching operations until issuance of the inching overheat caution, if issued, is uncertain. 3 - 60 Never continue stopping the m achine on a slope for a long time, keeping t he inching clutch slipp the gear shift lever to P (PARKING) positio If not necessary, do not put yo NOTICE aise the clutch temperature excessively and cause the seizure or abnormal wear.

Long time inching operations r aise the clutch temperature excessively an d cause the seizure or a bnormal wear. In case the clutch temperature r inching clutch overheat cautio ose excessively during inching operations, the inching clutch over heat caution is issued. ( The n lamp and the centralized warning lamp lig ht up, and the alarm bu zzer sounds intermittently.) For the measures to be taken when the inching clutch overheat caution l amp lights up, see the i tems in "INCHING CLUTCH OVERHEAT CAUTION LAMP (P AGE 3-18)". as they possibly cause issuance of the inching clutch overheat caution: pedal for a long time.

As a target, the continuation of using the inching pedal is within 10 ated "depression" and "release" of the inching pedal within a short time. overheat caution is likely to indicate that large loads are applied. while large loads are applied. overheat caution is likely to indicate that large loads are applied. s as lowering the engine speed, lightening loads on the blade, etc. Avoid the following operations as they possibly cause issuance of the inc hing clutch overheat ca 1) Continuous use of the inching seconds.

2) Operation of continuously repe ated "depression" and "release" of the inch ing pedal within a shor Issuance of the inching clutch overheat caution is likely to indicate that lar 3) Operation of the inching pedal Issuance of the inching clutch In this case, take such measure overheat caution is likely to indicate that lar s as lowering the engine speed, lightening loads on the blade, etc This pedal (11) cuts off the po When depressing the pedal, th Use this pedal when stopping off, or when shifting the directi on between forward and reverse. When the transmission is in F1 pedal makes it possible to ma which are suitable for light loa finishing.