Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION ADJUSTMENTS ADJUST OPERATOR'S SEAT WARNING (A) Fore-and-aft adjustment Pull lever (1) up, move the seat to the desired position, then release the lever. Fore-and-aft adjustment: 110 mm (4.3 in) (11 stages) 3 - 95 Park the machine in a safe pl ace and stop the engine when carrying out adjustme nt of the operator' Adjust the seat position at th e beginning of each shift or when operators change. Adjust the seat so that the br ake pedal can be depressed all the way down with th e operator's back against the bac (B) Adjusting reclining angle Pull lever (2) up, set the seat back to a position where it is easy to carry out operations, then re lease the lever.

back pressed against the seat back. When doing this, keep your If your back is not against th e seat back, the seat back may spring back suddenly. (C) Adjusting seat tilt Front tilt adjust the angle of the front of seat. Push lever (3) down and To raise the angle of th down and apply your w To lower the angle of th down and apply your w adjust the angle of the front of seat. e front of seat, keep the lever pushed eight to the rear of seat. e front of seat, keep the lever pushed eight to the front of seat. Rear tilt st the angle of the rear of the seat.

Pull lever (3) up and adju To raise the rear of the To lower the rear of th seat, keep the lever pulled up and raise yours elf slightly from t he rear of the e seat, keep the lever pulled up and apply your weight to the re Amount of tilt: Up 13 deg., d Adjusting seat height wer the seat by combining the front tilt and rear tilt. It is possible to raise or lo Use the front (rear) tilt ope horizontal. wer the seat by combining the front tilt an d rea r tilt. ration to set the seat to the desired height, then use the rear (fro nt) tilt to make the seat 2.4 in) Height adjustment: 60 mm (