Komatsu — OPERATIONS, CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION WARNING Emergency stop NOTICE completed that the vibration. If 3 - 105 abnormal or any other trouble occurs, turn the key in the starting switch to the OFF position. If the work equip ment is operated without warming up t he machine sufficiently, th e response o f the work equipment t o the control lever will be slow. The work eq uipment may not move as the operator desires. Follow all warm-up icularly in cold areas, make sure to war m up the machine properly NORMAL OPER After starting the e ngine, do not immediately start op erations. First, perform t he following operations and checks.

Do not accelerate th e engine suddenly until the warming-up Do not run the engin e at low idle or high idle continuously f or more than 20 minutes. If it is necessary to c ontinue to run the engine at idle, apply a load from time to time o r run the engi ne at a mid-range spee 1. Always wait f or the warming-up operation to b (until the engin idle speed of 8 2. After completi e idle speed is reduced from 1100 rp 00 rpm). ng the warming-up operation, ch gauges and c If any problem Run the engin gauge (1) ente aution lamps work properly. is found, carry out maintenance or e under low load until engine water rs the green range. ormal exhaust gas color, noise, or 3.

Check for abn any problem is found, contact your Komatsu distr