Komatsu — WORK WHICH CAN BE CARRIED OUT USING A MOTOR GRADER

. OPERATION OPERATION BANK CUTTING METHOD - RIGHT SIDE WARNING POSTURE (RIGHT SIDE) (PAGE 3-158)". REMARK The wheels should normally be almost perpendicular. 3 - 148 Lower the blade to the ground be fore removing the bank control lock pin. 1. The roadbed where the f oundation is to be dug must be u niform. 2. If the soil is hard, angle th e roadbed slightly towards the b ank to prevent the machine fr bank. om sliding to the side away from the 3. Set to the bank cut postur e. For details, see "BANK CUTTING 4. Rotate the circle and extend or retract the left and right blade lift cylinders to set to the bank slope face posture 5.

From the high bank position, rotate the blade so that the top of the blade is at the front. This sets it to the low bank posture, which is suited for scraping operations. REMARK If the top of the blade is rotated to the rear, the blade can be set to the reverse low bank posture, which makes it possible to cut the slope face while scraping up the soil. To scrape up the soil smoothly, a shallow angle slope is needed. Rotate the blade until the bottom of the blade is close to the front tires. Be careful not to let the blade hit the tires. 4. Rotate the circle and exte nd or retract the left and right bla de lift cylinders to set to t he bank slop e face po sture 5.

From the high bank positi on, rotate the blade so that the to p of I f the top of the blade is rotate d to the rear, the blade can be s et to the reverse low bank posture slope face while scraping up To scrape up the soil smooth ly, a shallow angle slope is needed. Rotate the blade until the bot ront tires. Be careful not to let the 6. Extend the left blade lift cutting edge of the blade wheels at the bottom of t cylinder, and set the tip of the left in line with the outside of the rear he slope face. rear 7. The rear right wheel mus t be in the V at the base of the sl ope face. 8. Extend the right blade lift cylinder and set the angle to the desired bank slope face 9.

Gradually progress with t he cutting.