Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE shifting cylinder piston rod, as follows. 3 - 155 Move the work equipm ent to the most suitable position fo r eac h operation a nd carry o ut operat ions efficie BLADE PROTRUSIO The degree of protrusio ontrol operation. If further pr while and change the otrusion is needed, sto grad er fo r a orizontal 1. Lower the blade to 2. Loosen the bolt hold ing the blade to the bracket a t the tip of t he cylinder rod, then re move the bolt and lock 3. 4. Retract or extend th Align the bolt hole in the blade. 5. Install the lock was her and bolt, then tighte n the bolt. Protrusion to righ Protrusion to left:

Standard positio BLADE PROPULSIO N ANGLE blade and the center line of the machine propulsion angle. ion angle to approximately 60 deg. for The angle between the body is called the blade Set the blade propuls ion angle to approximately for general cutting work, bu t set it narrower in the f ollowing si tuations. When the cutting res istance is high. . ulated in front of the blade dose not flow When the soil is hard When the soil accum smoothly.